FRONT BUMPER(for Sedan) REMOVAL

PROCEDURE

  1. REMOVE RADIATOR GRILLE SUB-ASSEMBLY

  2. REMOVE FRONT BUMPER ASSEMBLY

    1. B350496C01
      V100155

      Protective Tape

      Put protective tape around the front bumper assembly.

    2. B350499C01

      *1

      Pin Hold Clip

      *a

      90°

      Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.

      Tip:

      Use the same procedure for the RH side and LH side.

    3. Remove the clip.

      Tip:

      Use the same procedure for the RH side and LH side.

    4. B350497

      Remove the 8 screws.

    5. B350500

      Disengage the 4 claws as shown in the illustration.

      Tip:

      Use the same procedure for the RH side and LH side.

    6. B350501

      Using a clip remover, remove the 3 clips.

    7. B350502

      Disengage the 4 claws as shown in the illustration.

    8. w/ Fog Light:

      1. Pull back the side of the front bumper assembly and disconnect the 2 fog light connectors.

        Note:

        Do not apply excessive force when pulling back the front bumper assembly.

    9. w/ TOYOTA Parking Assist-sensor System:

      1. Disconnect the ultrasonic sensor connector.

    10. w/ Headlight Cleaner System:

      1. Disconnect the headlight cleaner hose and drain the washer fluid.

        Tip:

        Use a container to collect the washer fluid.

    11. Remove the front bumper assembly.