CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM(for 1ZR-FAE), Diagnostic DTC:P0741,P075B and P2757
| DTC Code | DTC Name |
|---|---|
| P0741 | Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) |
| P075B | Shift Solenoid "G" Performance or Stuck Off |
| P2757 | Torque Converter Clutch Pressure Control Solenoid Performance (Shift Solenoid Valve SLU) |
DESCRIPTION
The ECM uses the shift solenoid valves SC and SL to switch control of the shift solenoid valve SLU between forward and reverse clutch control and lock-up control in response to driving conditions.
If DTC P0741 is stored after the engine has stalled, the lock-up shift solenoid valve (shift solenoid valve SL) may be malfunctioning.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
MIL |
Memory |
|---|---|---|---|---|---|
P0741 |
Torque Converter Clutch Solenoid Performance (Shift Solenoid Valve SL) |
1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
|
|
Comes on |
DTC stored |
P075B |
Shift Solenoid "G" Performance or Stuck Off |
1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
|
|
Comes on |
DTC stored |
P2757 |
Torque Converter Clutch Pressure Control Solenoid Performance (Shift Solenoid Valve SLU) |
1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other
|
|
Comes on |
DTC stored |
MONITOR DESCRIPTION
When performing lock-up control (on/off) of the torque converter, the ECM compares the transmission revolution sensor (NT) output speed and engine speed (NE) to detect mechanical malfunctions in the shift solenoid valves SL and SC.
If the torque converter does not lock-up while a lock-up ON command is being sent, the ECM detects it as a mechanical malfunction of the shift solenoid valve SLU.
If the difference between the engine speed (NE) and transmission revolution sensor (NT) output speed or transmission revolution sensor (NIN) output speed and transmission revolution sensor (NT) output speed is outside of the threshold, the ECM detects the malfunction, illuminates the MIL and stores a DTC.
CAUTION / NOTICE / HINT
After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
Drive the vehicle and confirm the lock-up on and off conditions according to Road Test.
Turn the ignition switch off.
Perform step (1) again.
Check for DTCs again.
PROCEDURE
CHECK DTC OUTPUT (IN ADDITION TO DTC P0741, P075B AND P2757)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Powertrain > Engine and ECT > Trouble Codes
Read the DTCs using the GTS.
Tip:If any DTCs other than P0741, P075B or P2757 are output, perform troubleshooting for those DTCs first.
Result
Result
Proceed to
Only DTC P0741, P075B and/or P2757 is output
A
DTC P0741, P075B and/or P2757 and other DTCs are output
B
CLEAR DTC
Clear the DTCs.
Powertrain > Engine and ECT > Clear DTCs
Result
Proceed to
NEXT
PERFORM DRIVE TEST
CAUTION:Strictly observe posted speed limits, traffic laws and road conditions when performing a road test.
Note:This test must be performed after checking and confirming that the engine is normal.
Perform this test with the CVT fluid temperature between 50 and 100°C (122 and 212°F).
Perform the test with the air conditioning off.
Tip:Lock-up control will not operate when the CVT fluid temperature is 40°C (104°F) or less and the vehicle speed is 60 km/h (37 mph) or less, or when the CVT fluid temperature is 5°C (41°F) or less.
Lock-up control will not operate when the engine coolant temperature is 30°C (86°F) or less.
The lock-up OFF vehicle speed may vary depending on the electrical load, and air conditioning and brake operations.
Connect the GTS to the DLC3.
Start the engine.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Engine Speed, SPD (NT), SPD (NIN), Lock Up, SL Solenoid Status and Solenoid (SC).
According to the display on the GTS, read the Data List while driving.
Powertrain > Engine and ECT > Data List
Tester Display
Measurement Item
Range
Normal Condition
Diagnostic Note
Engine Speed
Engine speed
Min.: 0 rpm
Max.: 16383 rpm
680 to 780 rpm: Idling
When the crankshaft position sensor is malfunctioning, "Engine Speed" is approximately 0 rpm or varies greatly from the actual engine speed.
SPD (NT)
Input turbine speed (NT)
Min.: 0 rpm
Max.: 12750 rpm
Input turbine speed (NT) equal to engine speed (NE): Lock-up ON (After warming up engine)
Input turbine speed (NT) nearly equal to engine speed (NE): Lock-up OFF (Idling with shift lever in P or N)
0 rpm: Vehicle stopped with shift lever in R
Data is displayed in increments of 50 rpm.
SPD (NIN)
Primary pulley speed (NIN)
Min.: 0 rpm
Max.: 12750 rpm
0 rpm: Vehicle stopped
Primary pulley speed (NIN) equal to engine speed (NE): Lock-up ON (After warming up engine)
Data is displayed in increments of 50 rpm.
Lock Up
Lock-up
OFF or ON
ON: Lock-up operating
OFF: Lock-up not operating
-
SL Solenoid Status
Shift solenoid valve SL status
OFF or ON
ON: Lock-up permitted
OFF: Lock-up not permitted
-
Solenoid(SC)
Shift solenoid valve SC status
OFF or ON
ON: For 1 second after moving shift lever from P to D or R, or N to D or R
ON: Lock-up ON to OFF
OFF: Engine idling
-
Powertrain > Engine and ECT > Data List
Tester Display
Engine Speed
SPD (NT)
SPD (NIN)
Lock Up
SL Solenoid Status
Solenoid(SC)
Result
Result
Proceed to
When Lock Up is ON, the value of SPD (NT) is lower than the value of Engine Speed.
A
When SL Solenoid Status and Solenoid(SC) are OFF, the value of SPD (NT) is equal to the value of Engine Speed.
When SL Solenoid Status and Solenoid(SC) are ON, the difference between the value of SPD (NT) and SPD (NIN) is large.
When Lock Up is ON, the value of SPD (NT) is equal to the value of Engine Speed.
B
When SL Solenoid Status and Solenoid(SC) are OFF, the value of SPD (NT) is lower than the value of Engine Speed.
When SL Solenoid Status and Solenoid(SC) are ON, the value of SPD (NT) is equal to the value of SPD (NIN).
REPLACE CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY
Replace the continuously variable transaxle assembly and torque converter assembly.
Result
Proceed to
NEXT