FRONT BODY PILLAR CUT AND JOIN REPLACEMENT SECTIONS



  1. REMOVAL

    Symbol Meaning
    A002KYI Remove Weld Points
    A002KY8 Remove Weld Points
    A002KW2 Cut and Join Location
    A002KR4 Cut Location for Supply Parts

      REMOVAL POINT

    1. Reuse *a, as the area of the outer panel that is cut and joined is to the rear of the supplied part cut position.

    2. Remove the side panel gusset at the same time.

    A002KWGC01
    *1 Side Panel Gusset - -
    *b mm (in.) - -
    A002KU7
  2. INSTALLATION

    Symbol Meaning
    A002KYI Remove Weld Points
    A002KQT Spot Weld
    A002KRC Plug Weld
    A002KR9 Plug Weld
    A002KW2 Cut and Join Location
    A002KUS Butt Weld
    A002KW6 Body Sealer

      INSTALLATION POINT

    1. Before temporarily installing the new parts, weld the rocker outer panel, front body pillar lower reinforce, side inner panel, front body outer pillar and side panel gusset with the standard number of welding points.

    2. Inspect the fitting of the related parts around the new parts before welding. This affects the appearance of the finish.

    3. Temporarily install the new parts and measure each part of the new parts in accordance with the body dimension diagram. (See the body dimension diagram)

    4. Before installing a new part, apply body sealer.

      Tech Tips

      Apply sealer in an even, continuous bead.

    5. After welding, apply the foamed sealing material to the corresponding parts. (See the painting / coating)

    6. After welding, apply body sealer to the corresponding parts. (See the painting / coating)

    7. After applying the top coat, apply anti-rust agent to the internal panel portion of the closed section structural weld points.

    A002KS4C01
    *a mm (in.) - -
    A002KRZC01
    *1 Front Body Outer Pillar *2 Side Panel Gusset
    *3 Front Body Pillar Lower Reinforce *4 Side Inner Panel
    *5 Rocker Outer Panel - -
    A002KSG
    A002KWR