Click here

БЛОК СЦЕПЛЕНИЯ (для моделей с 5L-E) УСТАНОВКА

Click here
Click here Click here
  1. Click here

    INSTALL CLUTCH DISC ASSEMBLY


    1. A00JW1TE01

      Insert SST into the clutch disc. Then insert SST (together with the clutch disc) into the flywheel to install the clutch disc.

      09301-00110
      Table 1. Text in Illustration
      A00JWY4 Flywheel Side
      Note:

      Be sure to install the clutch disc so that it is facing in the correct direction.

  2. Click here

    INSTALL CLUTCH COVER ASSEMBLY


    1. Align the matchmarks on the clutch cover and flywheel.

      Table 2. Text in Illustration
      *a Matchmark
    2. Tighten the 6 bolts uniformly in the order shown in the illustration, starting with the bolt located near the knock pin on the top.

      09301-00110
      19 N*m 194 kgf*cm 14 in.*lbf
      Tip:

      Move SST up and down, and right and left lightly after checking that the clutch disc assembly is in the center, and then tighten the bolts.

  3. Click here

    INSPECT AND ADJUST CLUTCH COVER ASSEMBLY


    1. Using a dial indicator with a roller instrument, measure the diaphragm spring tip alignment.

      09333-00013
      Maximum non-alignment
      0.5 mm (0.0196 in.)

      • If the alignment is more than the maximum, use SST to adjust the diaphragm spring tip alignment.

  4. Click here

    INSTALL RELEASE FORK SUPPORT


    1. Install the release fork support to the manual transmission unit.

      39 N*m 400 kgf*cm 29 in.*lbf
  5. Click here

    INSTALL CLUTCH RELEASE BEARING ASSEMBLY


    1. Apply release hub grease to the clutch release bearing, and then install it to the clutch release fork with the clip.

      Grease
      Toyota Genuine Release Hub Grease or equivalent
      Table 3. Text in Illustration
      *a Release hub grease
  6. Click here

    INSTALL CLUTCH RELEASE FORK SUB-ASSEMBLY


    1. Install the clutch release fork.

      Note:

      After the installation, move the fork forward and backward to check that the release bearing slides smoothly.

    2. A00K167E01

      Apply clutch spline grease to the spline of the input shaft.

      Grease
      Toyota Genuine Clutch Spline Grease or equivalent
      Table 4. Text in Illustration
      *a Clutch spline grease
  7. Click here

    INSTALL CLUTCH RELEASE FORK BOOT

  8. Click here

    INSTALL MANUAL TRANSMISSION ASSEMBLY


    1. Install the manual transmission assembly (Click here).