FRONT SEAT ASSEMBLY(for Manual Seat) DISASSEMBLY

CAUTION / NOTICE / HINT

CAUTION:

Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedures listed below are for LHD vehicles.

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)

    Click here

  2. REMOVE FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)

    Click here

  3. REMOVE SEAT ADJUSTER COVER CAP LH


    1. A01COQW

      Remove the 2 seat adjuster cover caps from the front seat adjuster assembly LH.

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE LH


    1. A01COMJC01
      *1 Protective Tape

      Using a screwdriver, detach the claw to remove the reclining adjuster release handle LH.

      Tech Tips

      Tape the screwdriver tip before use.

  5. REMOVE VERTICAL ADJUSTING HANDLE LH


    1. A01CMZS

      Remove the screw and vertical adjusting handle LH.

  6. REMOVE FRONT SEAT CUSHION PROTECTOR


    1. A01COC6

      Remove the front seat cushion protector from the vertical adjusting handle LH.

  7. REMOVE FRONT SEAT CUSHION SHIELD LH


    1. A01CPSI

      Detach the 2 hooks to disconnect the 2 rubber bands.

    2. A01CQ22

      Using moulding remover A, detach the claw.

    3. A01CQVC

      Detach the 2 clips, claw and 3 guides to remove the front seat cushion shield LH.

  8. REMOVE FRONT INNER SEAT CUSHION SHIELD LH


    1. A01COLW

      Using moulding remover A, detach the claw.

    2. A01COX1

      Detach the claw and 3 guides to remove the front inner seat cushion shield LH.

  9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD LH


    1. A01H5MYC01
      B002K10 Fastening Tape

      Detach the fastening tape to disconnect the front seat side airbag wire harness.

    2. w/ Seat Heater System:


      1. A01CPKD

        Disconnect the connector.

      2. Detach the clamp to disconnect the seat heater wire harness.

      3. A01CNZE

        Disconnect the connector.

      4. Detach the 3 clamps to disconnect the seat heater wire harness.

    3. A01CNI6

      Detach the 3 hooks.

    4. A01CNW2

      Detach the 9 hooks.

    5. A01CQ2PC01
      *1 Protective Tape

      for Front Passenger Side:


      1. Using a screwdriver, detach the claw to disconnect the occupant detection sensor connector.

        Tech Tips

        Tape the screwdriver tip before use.

    6. Remove the separate type front seat cushion cover with pad LH.

  10. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER LH


    1. A01H81B

      Remove the 2 hog rings.

    2. A01H76V

      Remove the 14 hog rings.

    3. A01H5N2

      Slide the seat cover wire.

      Tech Tips

      Use the same procedure for both seat cover wires.

    4. A01H5UV

      Remove the 4 hog rings to remove the separate type front seat cushion cover LH from the separate type front seat cushion pad LH.

  11. REMOVE SEAT COVER WIRE


    1. A01H7AH

      Remove the seat cover wire.

  12. REMOVE FRONT SEAT HEADREST SUPPORT


    1. A01CNJPC01
      B002K10 Fastening Tape

      Detach the 2 pieces of fastening tape and pull out the 2 fasteners.

    2. A01CNU8

      Remove the 5 hog rings.

    3. A01H6FF

      Open the 2 fasteners.

    4. A01H6F6

      Detach the 4 claws to remove the 2 front seat headrest supports.

  13. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD


    1. A01CPDQ

      Remove the 2 nuts to disconnect the 3 seatback cover brackets.

    2. Remove the separate type front seatback cover with pad.

  14. REMOVE SEPARATE TYPE FRONT SEATBACK COVER LH


    1. A01H6MH

      Pass the 3 seatback cover brackets through the 3 holes of the separate type front seatback pad LH.

    2. A01H5OI

      Remove the 14 hog rings to remove the separate type front seatback cover LH from the separate type front seatback pad LH.

  15. REMOVE SEAT COVER WIRE


    1. Remove the seat cover wire.

      A01H6L5
  16. REMOVE SEATBACK FELT


    1. A01CRLH

      Remove the seatback felt from the separate type front seatback spring assembly LH.

  17. REMOVE FRONT SEAT AIRBAG ASSEMBLY LH

    Click here

  18. REMOVE SEPARATE TYPE FRONT SEATBACK SPRING ASSEMBLY LH


    1. A01CPTF

      Remove the 4 bolts.

    2. Detach the 4 guides to remove the separate type front seatback spring assembly LH from the front seat adjuster assembly LH.

  19. REMOVE FRONT NO. 1 SEATBACK HOOK


    1. A01COIJ

      Detach the 2 claws.

    2. A01CQ0X

      Remove the 2 front No. 1 seatback hooks from the front seatback spring sub-assembly LH.

  20. REMOVE FRONT SEATBACK EDGE PROTECTOR


    1. A01CQB6

      Detach the 2 claws and 4 guides to remove the 2 front seatback edge protectors.

  21. REMOVE FRONT SEATBACK SPRING SUB-ASSEMBLY LH


    1. A01CO1J

      Detach the 2 hooks to remove the front seatback spring sub-assembly LH from the front seatback frame sub-assembly LH.

  22. REMOVE FRONT SEAT CUSHION AIRBAG ASSEMBLY RH (for Front Passenger Side)

    Click here

  23. REMOVE FRONT LOWER SEAT CUSHION SHIELD LH


    1. A01CQFX

      Remove the screw.

    2. Detach the hook in the direction indicated by the arrow in the illustration.

    3. Detach the clip to remove the front lower seat cushion shield LH.

  24. REMOVE FRONT LOWER SEAT CUSHION SHIELD RH

    Tech Tips

    Use the same procedure described for the LH side.

  25. REMOVE FRONT SEAT CUSHION EDGE PROTECTOR LH


    1. A01CRDEC01
      *1 Clamp
      *2 Guide

      Detach the clamp and guide to remove the front seat cushion edge protector LH.

  26. REMOVE FRONT SEAT CUSHION EDGE PROTECTOR RH

    Tech Tips

    Use the same procedure described for the LH side.

  27. REMOVE SEAT POSITION AIRBAG SENSOR (for Driver Side)

    Click here

  28. REMOVE FRONT SEAT CUSHION SPRING SUB-ASSEMBLY LH


    1. A01CO5X

      Detach the 6 hooks to remove the front seat cushion spring sub-assembly LH from the front seat adjuster assembly LH.

  29. REMOVE SEAT TRACK ADJUSTING HANDLE


    1. A01CP9HC01
      *1 Spring

      Using a screwdriver, detach the 2 springs to remove the seat track adjusting handle.

  30. REMOVE SEAT HEATER CONTROL SUB-ASSEMBLY LH (w/ Seat Heater System)


    1. A01COQI

      Detach the 2 clamps to remove the seat heater control sub-assembly LH.