DESCRIPTION
A malfunction occurs in LIN communication of the components related to the rain sensor between the rain sensor and windshield wiper relay assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
When using the GTS with the power switch off to troubleshoot:
Connect the GTS to the vehicle, and turn a courtesy light switch on and off at 1.5 second intervals until communication between the GTS and vehicle begins.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
PROCEDURE
CHECK HARNESS AND CONNECTOR (RAIN SENSOR - WINDSHIELD WIPER RELAY ASSEMBLY)
Disconnect the I56 windshield wiper relay assembly connector.
Disconnect the T8 rain sensor connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||
|---|---|---|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - BATTERY AND BODY GROUND)
| *a | Front view wire harness connector (to Windshield Wiper Relay Assembly) |
Disconnect the windshield wiper relay assembly connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
Measure the voltage according to the value(s) in the table below.
| Standard Voltage | ||||||
|---|---|---|---|---|---|---|
|
| Result | |||
|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
CHECK WINDSHIELD WIPER RELAY ASSEMBLY
Temporarily replace the windshield wiper relay assembly with a new or normally functioning one.
Check the rain sensor function.
| Result | |||
|---|---|---|---|
|
| Rain sensor function is normal |
|
END (WINDSHIELD WIPER RELAY ASSEMBLY IS DEFECTIVE) |
| Rain sensor function is not normal |
|
REPLACE RAIN SENSOR Click here |