FRONT AXLE HUB ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE FRONT WHEEL

    Click here

  4. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  5. REMOVE FRONT DISC

    Click here

  6. INSPECT FRONT AXLE HUB BEARING LOOSENESS

    B002JFO

    1. Using a dial indicator, check for looseness near the center of the front axle hub sub-assembly.

      Maximum
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the looseness is more than the maximum, replace the front axle hub sub-assembly.

  7. INSPECT FRONT AXLE HUB RUNOUT

    B002J7Z

    1. Using a dial indicator, check for runout on the surface of the front axle hub sub-assembly outside the front hub bolt.

      Maximum
      0.05 mm (0.00197 in.)

      Note

      Make sure that the dial indicator is set perpendicular to the measurement surface.

      If the runout is more than the maximum, replace the front axle hub sub-assembly.

  8. INSTALL FRONT DISC

    Click here

  9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH

    Click here

  10. INSTALL FRONT WHEEL

    Click here

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    2. w/o Spare tire:

      Install the battery service cover and attach the 2 claws.