REAR AXLE HUB BOLT REPLACEMENT

CAUTION / NOTICE / HINT

Note


  • When the brake pedal is first depressed after replacing the brake pads or pushing back the disc brake piston, DTC C1214 may be output. As there is no malfunction, clear the DTC.

  • While the auxiliary battery is connected, even if the power switch is off, the brake control system activates when the brake pedal is depressed or the door courtesy switch is turned on. Therefore, even if only brake shoes are to be removed and installed, be sure to perform the Disable Brake Control procedure and disconnect the cable from the negative (-) terminal of the auxiliary battery before beginning work.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notice before proceeding with work.

    Click here

  2. DISABLE BRAKE CONTROL

    Click here

  3. REMOVE REAR WHEEL

    Click here

  4. DISCONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH


    1. B002KJD

      Disconnect the parking brake wire from the rear disc brake caliper assembly LH.

    2. B002I0L

      Remove the 2 bolts, and disconnect the rear disc brake caliper assembly.

      Note

      Use wire or an equivalent tool to keep the brake caliper from hanging down by the flexible hose.

  5. REMOVE REAR DISC

    Click here

  6. REMOVE REAR AXLE HUB BOLT LH

    B002I8IC02
    *1 Nut
    *a Hold
    *b Turn

    1. Temporarily install 2 nuts and 2 washers to the rear axle hub bolt as shown in the illustration.

    2. Using SST and a brass bar or an equivalent tool to hold the hub and bearing assembly, remove the rear axle hub bolt.

      SST
      09611-12010
  7. INSTALL REAR AXLE HUB BOLT LH

    B002I4KC02
    *1 Washer
    *2 Nut
    *a Hold
    *b Turn

    1. Install a washer and nut to a new rear axle hub bolt as shown in the illustration.

    2. Using a brass bar or an equivalent tool to hold the hub and bearing assembly, install the rear axle hub bolt by tightening the nut.

  8. INSTALL REAR DISC

    Click here

  9. CONNECT REAR DISC BRAKE CALIPER ASSEMBLY LH


    1. Connect the rear disc brake caliper assembly LH with the 2 bolts.

      Torque:
      104 N*m  { 1061 kgf*cm, 77 ft.*lbf }
    2. Connect the parking brake wrie to the rear disc brake caliper assembly LH.

  10. INSTALL REAR WHEEL

    Click here

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal and tighten the nut.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }
    2. w/o Spare tire:

      Install the battery service cover and attach the 2 claws.