LANE DEPARTURE ALERT SYSTEM(w/ Steering Control) Power Source Circuit

DESCRIPTION

This circuit provides power to operate the lane departure warning camera.

WIRING DIAGRAM

A01CQ0OE03
*1 from IG1 NO.1 Relay
*2 ECU-IG NO.1
*3 Lane Departure Warning Camera

CAUTION / NOTICE / HINT

Note

Inspect the fuses for circuits related to this system before performing the following procedure.

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (LANE DEPARTURE WARNING CAMERA - BATTERY AND BODY GROUND)


    1. A01CPGIC09
      *a

      Front view of wire harness connector

      (to Lane Departure Warning Camera)

      Disconnect the lane departure warning camera connector.

    2. Measure the voltage and resistance according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      T10-7 (IGB) - Body ground Power switch on (IG) 11 to 14 V
      T10-7 (IGB) - Body ground Power switch off Below 1 V
      Standard Resistance
      Tester Connection Condition Specified Condition
      T10-11 (GND) - Body ground Always Below 1 Ω
      Result
      Proceed to
      OK
      NG

    OK
    NG