REAR BRAKE FLEXIBLE HOSE INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The following procedure is for the LH side.

Note


  • Because the RH side flexible hose and LH side flexible hose are not interchangeable, verify the part number when installing the rear flexible hoses.

  • If the rear flexible hoses are to be reused, connect them after checking the identification marks placed when each hose was disconnected.

PROCEDURE


  1. INSTALL REAR FLEXIBLE HOSE LH


    1. Connect the flexible hose with a new gasket and a new union bolt to the disc brake cylinder.

      Torque:
      30.4 N*m  { 310 kgf*cm, 22 ft.*lbf }

      Tech Tips

      Install the flexible hose lock securely in the lock hole in the cylinder.

    2. Install a new clip to the rear flexible hose.

      Note

      Install the clip as far as it will go.

    3. B002K3GC02
      *a Torque Wrench Fulcrum Length

      Using a union nut wrench, connect the flexible hose to the brake tube while holding the flexible hose with a wrench.

      Torque:
      Specified tightening torque
      15.2 N*m  { 155 kgf*cm, 11 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using union nut wrench (fulcrum length of 22 mm (0.8661 in.)) + torque wrench (fulcrum length of 162 mm(6.3779 in.)): 13.4 N*m (137 kgf*cm,10 ft.*lbf)

      Note


      • Do not bend or damage the brake tube.

      • Do not allow any foreign matter such as dirt and dust to enter the brake tube from the connecting point.

  2. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  3. INSTALL DECK FLOOR BOX LH (w/ Spare Tire)

    Click here

  4. INSTALL REAR DECK FLOOR BOX (w/ Spare Tire)

    Click here

  5. INSTALL NO. 3 DECK BOARD SUB-ASSEMBLY (w/ Spare Tire)

    Click here

  6. BLEED BRAKE LINE

    Click here

  7. INSTALL REAR WHEEL

    Click here