BRAKE MASTER CYLINDER INSTALLATION


  1. INSPECT AND ADJUST BRAKE BOOSTER PUSH ROD

    A01KFRIE01

    1. Apply SST to the master cylinder.

      SST
      09737-00013
    2. Set SST on the master cylinder, lower the pin of the SST until it slightly touches the piston.

    3. Apply the chalk to the flat surfaced tip of the SST pin.

    4. Turn SST upside down and place it clearance between the brake booster and SST.

      Clearance
      0 mm (0 in.)

      Tech Tips


      • If there is a clearance between the SST main body and the booster shell. It means that the specified value, and no chalk attachment on the booster push rod means that it is more than the specified value.

      • Brake booster push rod clearance before shipment is adjusted to be -0.1 (Push up) - 0.11 mm (-0.0039 - 0.0043 in.).

    5. A01KEYTE01

      Using SST, adjust the booster push rod length until the push rod lightly touches the pin head.

      Torque:
      7.4 N*m  { 75 kgf*cm, 65 in.*lbf }
  2. INSTALL BRAKE MASTER CYLINDER SUB-ASSEMBLY


    1. Install the master cylinder.

    2. Install the master cylinder support with the 2 bolts and 2 nuts.

      Torque:
      13 N*m  { 130 kgf*cm, 95 in.*lbf }
    3. Connect the 2 reservoir tubes.

    4. A01KF5L

      Using union nut wrench 10 mm, connect the 2 brake tubes to the master cylinder.

      Torque:
      15 N*m  { 155 kgf*cm, 11 ft.*lbf }
  3. INSTALL COMBINATION METER ASSEMBLY


    1. Connect the 4 connectors to the combination meter and install the combination meter with the 3 screws.

  4. INSTALL INSTRUMENT CLUSTER FINISH PANEL

  5. INSTALL STEERING COLUMN COVER UPR

  6. INSTALL STEERING COLUMN COVER LWR


    1. Install the steering column cover LWR with the 4 screws.

  7. FILL RESERVOIR WITH BRAKE FLUID

  8. BLEED MASTER CYLINDER

    A01KECL

    Tech Tips

    If the master cylinder has been disassembled or if the reservoir becomes empty, bleed the air from the master cylinder.


    1. Disconnect the brake lines from the master cylinder.

    2. Slowly depress the brake pedal and hold it.

    3. A01KFNA

      Block off the outer holes with your fingers, and release the brake pedal.

    4. Repeat (b) and (c) 3 or 4 times.

  9. BLEED BRAKE LINE


    1. Connect the vinyl tube to the brake caliper.

    2. Depress the brake pedal several times, then loosen the bleeder plug with the pedal held down.

    3. At the point when fluid stops coming out, tighten the bleeder plug, then release the brake pedal.

    4. Repeat (b) and (c) until all the air in the fluid has been bled out.

    5. Repeat the above procedure to bleed the air out of the brake line for each wheel.

      Torque:
      11 N*m  { 110 kgf*cm, 8 ft.*lbf }
  10. CHECK FLUID LEVEL

  11. INSTALL OIL RESERVOIR TANK COVER LH (LHD STEERING POSITION TYPE)

  12. INSTALL OIL RESERVOIR TANK COVER RH (RHD STEERING POSITION TYPE)

  13. CHECK BRAKE FLUID LEAKAGE