DESCRIPTION
| DTC No. | DTC Detecting Condition | Trouble Area |
|---|---|---|
| C1249/49 | Under the condition that ECU IG1 terminal voltage is 9.5 V to 18.5 V and also ABS is not in operation, when the wire break of the stop switch circuit has been continued for 0.3 seconds or more. |
|
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
CHECK STOP LIGHT SWITCH OPERATION
Check that the stop light lights up when brake pedal is depressed and turns off when the brake pedal is released.
| OK |
|
CHECK SKID CONTROL ECU TERMINAL VOLTAGE (STP TERMINAL) Click here |
| NG |
|
CHECK STOP LIGHT SWITCH CIRCUIT
Check for open and short circuit in harness and connector of the stop light circuit Click here.
| NG |
|
REPAIR OR REPLACE STOP LIGHT SWITCH CIRCUIT |
| OK |
|
CHECK SKID CONTROL ECU TERMINAL VOLTAGE (STP TERMINAL)
Remove the skid control ECU with connectors still connected.
Measure voltage between terminal STP of skid control ECU and body ground when brake pedal is depressed.
| OK |
|---|
| Voltage: 8 - 14 V |
| OK |
|
CHECK AND REPLACE SKID CONTROL ECU ASSEMBLY |
| NG |
|
CHECK HARNESS AND CONNECTOR (STOP LIGHT SWITCH - SKID CONTROL ECU)
Check for open and short circuit in harness and connector between stop light switch and skid control ECU Click here.
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOM TABLE