GENERATOR (w/o DPF) REASSEMBLY


  1. INSTALL GENERATOR DRIVE END FRAME BEARING


    1. A01KGXD

      Using SST and a press, press in a new bearing.

      SST
      09950-60010   ( 09951-00470 )
      09950-70010   ( 09951-07100 )
    2. A01KIGSE04
      Text in Illustration
      *1 Claw

      Align the claws of the bearing retainer with the grooves inside the drive end frame.

    3. Install the bearing retainer with the 4 screws.

      Torque:
      2.3 N*m  { 23 kgf*cm, 20 in.*lbf }
  2. INSTALL GENERATOR ROTOR ASSEMBLY


    1. Install the rotor and washer to the drive end frame.

  3. INSTALL GENERATOR COIL ASSEMBLY


    1. A01KGNEE03
      Text in Illustration
      *a Deep Socket Wrench (21 mm)

      Using deep socket wrench (21 mm) and a press, slowly press in the generator coil assembly.

    2. Install the generator coil assembly with the 4 through bolts.

      Torque:
      5.8 N*m  { 59 kgf*cm, 51 in.*lbf }
  4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    1. A01KH7BE09
      Text in Illustration
      *1 Pin

      While pushing the 2 brushes to the inside of the generator brush holder assembly, insert a φ1.0 mm (0.039 in.) pin into the generator brush holder hole.

    2. A01KGNLE05
      Text in Illustration
      *1 Pin

      Install the brush holder assembly with the 2 screws.

      Torque:
      1.8 N*m  { 18 kgf*cm, 16 in.*lbf }
    3. Pull out the pin from the brush holder assembly.

  5. INSTALL TERMINAL INSULATOR


    1. A01KFLY

      Install the terminal insulator.

  6. INSTALL GENERATOR REAR END COVER


    1. Install the generator rear end cover with the 3 nuts.

      Torque:
      4.6 N*m  { 47 kgf*cm, 41 in.*lbf }
  7. INSTALL GENERATOR WITH CLUTCH PULLEY


    1. Install the pulley by hand.

    2. Install SST to the pulley and vise as shown in the illustration.

      SST
      09820-63020
    3. Turn SST (B) counterclockwise, and tighten the pulley.

      SST
      09820-63020
      Torque:
      111 N*m  { 1127 kgf*cm, 82 ft.*lbf }

      Note

      Refer to the torque above when not using SST. When using SST, calculate the torque in accordance with the lengths of SST and the torque wrench Click here.

    4. Check that the generator pulley rotates smoothly.

    5. Install the generator pulley cap.