CLUTCH PEDAL ADJUSTMENT


  1. INSPECT AND ADJUST CLUTCH PEDAL SUB-ASSEMBLY


    1. Turn over the floor carpet.

    2. A01KEQCE02
      Text in Illustration
      *a Push Rod Play and Free Play Adjust Point
      *b Pedal Height Adjust Point
      *c Push Rod Play
      *d Pedal Height

      Check that the pedal height is correct.

      Pedal height from asphalt sheet
      RHD, 2KD-FTV, Single Tire
      149.4 to 159.4 mm (5.882 to 6.276 in.)
      RHD, 2KD-FTV, Double Tire
      156.6 to 166.6 mm (6.165 to 6.559 in.)
      LHD, 2KD-FTV, Single Tire
      159.7 to 169.7 mm (6.287 to 6.681 in.)
      LHD, 2KD-FTV, Double Tire
      167.0 to 177.0 mm (6.575 to 6.968 in.)
      RHD, 5L
      149.4 to 159.4 mm (5.882 to 6.276 in.)
      LHD, 5L
      156.6 to 166.6 mm (6.165 to 6.559 in.)
    3. Adjust the pedal height.


      1. Loosen the lock nut and turn the stopper bolt until the height is correct. Tighten the lock nut.

        Torque:
        11.5 N*m  { 117 kgf*cm, 8.5 ft.*lbf }
    4. Check that the pedal free play and push rod play are correct.


      1. Depress the pedal until the clutch resistance begin to be felt.

        Pedal free play
        5.0 to 18.0 mm (0.197 to 0.709 in.)
      2. Gently depress the pedal until the resistance begins to increase a little.

        Push rod play at pedal top
        1.0 to 5.0 mm (0.039 to 0.197 in.)
    5. A01KGNME01
      Text in Illustration
      *a Pedal Free Play

      Adjust the pedal free play and push rod play.


      1. Loosen the lock nut and turn the push rod until the free play and push rod play are correct.

      2. Tighten the lock nut.

      3. After adjusting the pedal free play, check the pedal height.

    6. A01KFTPE01
      Text in Illustration
      *a Full Stroke End Position
      *b 25 mm (0.984 in.) or more
      *c Release Point

      Check the clutch release point.


      1. Pull the parking brake lever and install wheel stopper.

      2. Start the engine and idle the engine.

      3. Without depressing the clutch pedal, slowly shift the shift lever into reverse position until the gears contact.

      4. Gradually depress the clutch pedal and measure the stroke distance from the point the gear noise stops (release point) to the full stroke end position.

        Standard distance
        25 mm (0.984 in.) or more (From pedal stroke end position to release point)

        If the distance is not as specified, perform the following operations.


        • Inspect pedal height.

        • Inspect push rod play and pedal free play.

        • Bleed the clutch line.

        • Inspect the clutch cover and disc.