EMISSION CONTROL SYSTEM TC Terminal Circuit

DESCRIPTION

Terminals TE1 is located in the check connector.

The check connector is located in the engine compartment. When these terminals are connected with the E1 terminal, DTC in the normal mode can be read from the glow indicator light in the combination meter.

WIRING DIAGRAM

A01KEQIE01

INSPECTION PROCEDURE

Tech Tips


  • If terminals TE1 is connected with terminal E1.


  • Even though terminal TE1 is not connected with terminal E1, the check glow indicator light blinks.


  • For the above phenomenon, the likely cause is an open or short in the wire harness, or malfunction inside the emission ECU.

PROCEDURE


  1. CHECK EMISSION CONTROL ECU


    1. Turn the ignition switch ON.

    2. A01KERPE01

      Measure the voltage between terminals TE1 and E1 of the check connector.

      VOLTAGE
      9 - 14 V

    OK
    NG
  2. CHECK WIRE HARNESS


    1. A01KERPE02

      Check the continuity between terminal E1 of the check connector and body ground.

      RESISTANCE
      1 Ω or less

    NG
    OK
  3. CHECK WIRE HARNESS OR CONNECTOR (EMISSION ECU - CHECK CONNECTOR)


    1. A01KF5EE02
      A01KERPE03

      Disconnect the emission ECU connector.

    2. Check the continuity between TE1 of the check connector and TE1 of the ECU connector.

      RESISTANCE
      1Ω or less

    NG
    OK