EMISSION CONTROL SYSTEM, Diagnostic DTC:22

DTC Code DTC Name
22 Water Temperature Sensor Circuit Malfunction

DESCRIPTION

The engine coolant temperature sensor senses the coolant temperature. A thermistor built in the sensor changes the resistance value according to the coolant temperature. The lower the coolant temperature is, the greater the thermistor resistance value becomes, and the higher the coolant temperature is, the lower the thermistor resistance value becomes (See Fig.1).

The engine coolant temperature sensor is connected to the emission ECU (See below). The 5 V power source voltage in the emission ECU is applied to the engine coolant temperature sensor from the terminal THW via a resistor R. That is, the resistor R and the engine coolant temperature sensor are connected in series. When the resistance value of the engine coolant temperature sensor changes in accordance with changes in the coolant temperature, the potential at terminal THW also changes. Based on this signal, the emission ECU increases the fuel injection volume to improve driveability during the cold engine operation.

A01KETEE01
DTC No. DTC Detecting Condition Trouble Area
22 Open or short in engine coolant temp. sensor circuit for 0.5 sec. or more
  • Open or short in engine coolant temp. sensor circuit


  • engine coolant temp. sensor


  • Emission ECU

WIRING DIAGRAM

A01KFVEE01

INSPECTION PROCEDURE

Tech Tips

If DTC "22" (water temperature sensor circuit), "31" (vacuum sensor circuit) and "41" (throttle position sensor circuit) are output simultaneously, E2 (sensor ground) may be open.

PROCEDURE


  1. CHECK EMISSION CONTROL ECU


    1. Turn the ignition switch ON.

    2. A01KHLFE01

      Measure the voltage between terminals THW and E2 of the emission ECU.

      VOLTAGE
      Engine coolant temp. °C (°F) Voltage
      20 (68) 0.5 - 3.4 V
      80 (176) 0.2 - 1.0 V

    OK
    NG
  2. INSPECT ENGINE COOLANT TEMPERATURE SENSOR


    NG
    OK
  3. CHECK WIRE HARNESS OR CONNECTOR (EMISSION ECU-ENGINE COOLANT TEMPERATURE SENSOR)


    1. Disconnect the coolant temperature sensor connector.

    2. Disconnect the emission ECU connector.

    3. A01KH0WE01

      Check the continuity between terminals 2 of the coolant temperature sensor harness connector and THW of the ECU connector Click here.

      RESISTANCE
      1Ω or less
    4. A01KHFX

      Check for short between terminals 2 of the coolant temperature sensor harness connector and THW of the ECU connector Click here.

      RESISTANCE
      1MΩ or more
    5. Check the continuity between terminals 1 of the coolant temperature sensor harness connector and E2 of the ECU connector Click here.

      RESISTANCE
      1MΩ or less
    6. Check for short between terminals 1 of the coolant temperature sensor harness connector and E2 of the ECU connector Click here.

      RESISTANCE
      1M Ωor more

    NG
    OK