DESCRIPTION
The engine speed sensor in the engine control system contains a signal plate and a pickup coil for NE signal. The NE signal plate has 37 teeth and is mounted in the injection pump. The NE signal sensor generates 37 signals of 2 engine revolutions. The emission ECU detects the engine speed and cam lift position of the injection pump. The emission ECU uses NE signals for injection timing control. And also NE signal is used for injection volume control.
| DTC No. | DTC Detecting Condition | Trouble Area |
|---|---|---|
| 13 | No NE signal to emission ECU for 0.5 sec. or more at 1,000 rpm or more |
|
| Reference |
|---|
| INSPECTION USING OSCILLOSCOPE |
During cranking or idling, check the waveform between terminals NE+ and NE- of emission ECU.
Tech Tips
The correct waveform is shown.
WIRING DIAGRAM
INSPECTION PROCEDURE
PROCEDURE
CHECK INJECTION PUMP ASSEMBLY (ENGINE SPEED SENSOR)
| NG |
|
REPLACE INJECTION PUMP ASSEMBLY (ENGINE SPEED SENSOR) |
| OK |
|
CHECK WIRE HARNESS AND CONNECTOR (EMISSION ECU-ENGINE SPEED SENSOR))
Disconnect the engine speed sensor connector.
Disconnect the emission ECU connector.
Check the continuity between terminals 1 of the engine speed sensor harness connector and NE+ of the ECU connector Click here.
| RESISTANCE |
|---|
| 1 Ω or less |
Check for short between terminals 1 of the engine speed sensor harness connector and NE+ of the ECU connector Click here.
| RESISTANCE |
|---|
| 1 MΩ or more |
Check the continuity between terminals 2 of the engine speed sensor harness connector and NE- of the ECU connector Click here.
| RESISTANCE |
|---|
| 1 Ω or less |
Check for short between terminals 2 of the engine speed sensor harness connector and NE- of the ECU connector Click here.
| RESISTANCE |
|---|
| 1 MΩ or more |
| NG |
|
REPAIR OR REPLACE WIRE HARNESS OR CONNECTOR |
| OK |
|
INSPECT SENSOR INSTALLATION (ENGINE SPEED SENSOR)
| NG |
|
TIGHTEN SENSOR (ENGINE SPEED SENSOR) |
| OK |
|
CHECK AND REPLACE EMISSION CONTROL ECU Click here