FUEL INJECTION PUMP INSPECTION


  1. INSPECT INJECTION PUMP DELIVERY VALVE SUB-ASSEMBLY

    Note

    Do not touch the sliding surfaces of the pump plunger and delivery valves.


    1. A01KFES

      Pull up the valve and release it. Check that it sinks smoothly to the valve seat.

      If the operation is not as specified, replace the valve as a set.

      Tech Tips

      Before using a new valve set, wash off the rust prevention compound with light oil or gasoline. Then re-wash it with diesel fuel and perform the above tests.

  2. INSPECT PUMP PLUNGER AND SPILL RING


    1. A01KEM3

      Tilt the spill ring (distributive head) slightly, and pull out the plunger.

    2. When released, the plunger should sink down smoothly into the spill ring (distributive head) by its own weight.

    3. Rotate the plunger, and repeat the test at various positions.

      If the plunger sticks at any position, replace the parts as a set.

      Note

      Do not touch the sliding surface of the pump plunger.

    4. A01KGFS

      Insert the governor link ball pin into the spill ring, and check that it moves smoothly without any play.

  3. INSPECT PLUNGER SPRINGS


    1. A01KHWJE01
      Text in Illustration
      *a Deviation

      Using a square steel, check the deviation of the plunger springs.

      Maximum deviation
      2.0 mm (0.079 in.)

      If the deviation is greater than the maximum, replace both springs.

  4. INSPECT SPRING


    1. A01KI68

      Using vernier calipers, measure the free length of each spring.

      Spring free length:
      Delivery valve spring 24.4 mm (0.961 in.)
      Plunger spring 30.0 mm (1.181 in.)
      Coupling spring 16.6 mm (0.654 in.)
      Pneumatic bellows spring (w/ HAC) 30.0 mm (1.181 in.)

      If the free length is not as specified, replace the spring(s).

  5. INSPECT ROLLER RING AND ROLLER


    1. A01KI8J

      Using a dial indicator, measure the roller height.

      Maximum roller height variation
      0.02 mm (0.0008 in.)

      If the variation is greater than the specification, replace the roller ring and roller as a set.

  6. INSPECT FUEL CUT SOLENOID ASSEMBLY


    1. A01KFBIE01
      Text in Illustration
      *1 Ohmmeter

      Using an ohmmeter, measure the resistance between the terminal and solenoid body.

      Resistance
      9.5 to 11.9 Ω at 20°C (68°F)
  7. INSPECT ENGINE SPEED SENSOR


    1. A01KIEYE01
      Text in Illustration
      *A w/ TCV
      *B w/o TCV
      *1 Ohmmeter

      Using an ohmmeter, measure the resistance between terminals 1 and 2.

      Resistance
      650 to 970 Ω at 20°C (68°F)

      If the resistance is not as specified, replace the sensor.

  8. INSPECT TIMING CONTROL VALVE (w/ TCV)


    1. A01KFREE01
      Text in Illustration
      *1 Battery

      Connect the valve body and terminal to the battery terminals.

    2. You should feel click from the control valve when the battery power is connected and disconnected.

      If the control valve is not operating properly, replace it.