INSTALL RADIATOR TANK UPPER
Install the punch assembly to the overhaul handle, inserting it in the hole in part A as shown in the illustration.
While gripping the handle, adjust the stopper bolt so that dimension B is as specified below.
| Dimension B |
|---|
| 7.4 to 7.8 mm (0.29 to 0.30 in.) |
Check that there are no foreign objects in the core plate groove, and install a new O-ring. Make sure the O-ring is not twisted.
Note
When cleaning the core plate groove, lightly rub it with sandpaper without scratching it.
Tap the lock plate with a plastic-faced hammer so that there is no gap between the lock plate and the tank.
Lightly press the crimping tool against the core plate in the order shown in the illustration. After repeating this a few times, fully crimp the core plate by squeezing the handle until stopped by the stopper bolt.
Note
For positions where the crimping tool is not usable, crimp by using pliers.
Crimp according to the order shown in the illustration.
Check the dimension D after crimping.
| Standard dimension |
|---|
| 7.4 to7.8 mm (0.29 to 0.30 in.) |
In the event that the dimension D does not fall within the standard limit, adjust the stopper bolt of the handle once again and recrimp.
Note
Check the dimensions at both ends of the core plate as well as around the central portion where the crimping has not been performed (under the pipe, etc.).
Others:
Mark for the first repair for the second repair at a well visible place in the upper tank.
Note
The radiator can only be recrimped twice. After the second time, the radiator core must be replaced.
INSTALL RADIATOR TANK LOWER
Tech Tips
The installation procedure of the radiator tank lower is the same as that of the radiator tank upper.
INSPECT FOR COOLANT LEAK
Assemble the plug handle as shown in the illustration and tighten the nut until the washer, the plug and the handle are in light contact with each other.
Using SST, plug the inlet and outlet pipes of the radiator.
Using a radiator cap tester, apply pressure to the radiator.
| Test pressure |
|---|
| 118 kPa (1.2 kgf/cm2, 17 psi) |
Tech Tips
On radiators with resin tanks, there is a clearance between the core plate and tank plate where a minute amount of air will remain, giving the appearance of an air leak when the radiator is submerged in water. Therefore, before performing the water leak test, first swirl the radiator around in the water until all air bubbles disappear.
INSTALL RADIATOR SIDE PLATE
Install the all square head bolts to install the left and the right side plates.