THERMOSTAT INSTALLATION


  1. INSTALL THERMOSTAT


    1. A01CIICE01

      Apply a continuous bead of seal packing (diameter 1.5 to 2.5 mm (0.06 to 0.10 in.)) as shown in the illustration.

      Seal packing
      Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent.

      Note


      • Remove any oil from the contact surface.

      • Install the water pump within 3 minutes of applying the seal packing.

      • Do not start the engine for at least 2 hours after the installation.

    2. A01CI6X

      Install a new gasket onto the thermostat.

    3. Align the jiggle valve to the position shown in the illustration and install the thermostat.

    4. A01CGNU

      Install the water outlet with the 3 bolts.

      Torque:
      29 N*m  { 290 kgf*cm, 21 ft.*lbf }
  2. CONNECT RADIATOR HOSE INLET


    1. A01CJ8P

      Connect the radiator hose inlet with the clip.