INTAKE MANIFOLD INSTALLATION


  1. INSTALL INTAKE MANIFOLD


    1. A01CIYZE01
      Text in Illustration
      *1 Seal Packing

      Apply seal packing to the areas shown in the illustration.

      Seal packing
      Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent
      Standard seal diameter
      1.5 to 2.5 mm (0.0591 to 0.0984 in.)

      Note


      • Remove any oil from the contact surface.

      • Install the intake manifold within 5 minutes after applying seal packing.

      • Do not start the engine for at least 2 hours after installation.

    2. Install the intake manifold with the 8 bolts and 2 nuts.

      Torque:
      29 N*m  { 291 kgf*cm, 21 ft.*lbf }
    3. Install the wire harness clamp bracket with the bolt.

      Torque:
      29 N*m  { 291 kgf*cm, 21 ft.*lbf }
    4. Install the wire harness clamp bracket with the 2 bolts.

      Torque:
      29 N*m  { 291 kgf*cm, 21 ft.*lbf }
    5. Cold Area Specification Vehicles:

      Attach the 2 clamps.

  2. INSTALL NO. 1 INTAKE PIPE


    1. Install the No. 1 intake pipe with the 3 bolts and 2 nuts.

      Torque:
      29 N*m  { 291 kgf*cm, 21 ft.*lbf }
  3. INSTALL INTAKE AIR TEMPERATURE SENSOR


    1. Install a new gasket to the intake air temperature sensor.

    2. Using a 14 mm union nut wrench, install the intake air temperature sensor.

      Torque:
      20 N*m  { 200 kgf*cm, 14 ft.*lbf }

      Note

      Use the formula to calculate special torque values for situations where a union nut wrench is combined with a torque wrench Click here.

    3. Connect the wire harness clamp bracket with the bolt.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }
    4. Connect the clamp and intake air temperature sensor connector.

  4. INSTALL COMMON RAIL ASSEMBLY

    Click here

  5. INSTALL EGR VALVE ASSEMBLY

    Click here

  6. INSTALL VENTURI ASSEMBLY

    Click here