ECD SYSTEM, Diagnostic DTC:P0610

DTC Code DTC Name
P0610 Control Module Vehicle Options Error

DESCRIPTION

P0610
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Ignition switch ON for 1 second

The stored vehicle information is abnormal.

(1 trip detection logic)

ECM

INSPECTION PROCEDURE

Note

After replacing the ECM, the new ECM needs registration Click here and initialization Click here.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Replace the normal DLC3 cable (12 V specification) for the intelligent tester with the 24 V DLC3 cable.

      Note

      Be sure to use the 24 V DLC3 cable when connecting the intelligent tester to the DLC3. Using the normal DLC3 cable (12 V specification) will cause damage to the tester.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the tester on.

    5. Clear the DTCs Click here.

    6. Turn the ignition switch off and wait for 30 seconds or more.

    7. Turn the ignition switch to ON.

    8. Enter the following menus: Powertrain / Engine and ECT / DTC.

    9. Read the DTCs.

      Result
      Result Proceed to
      DTC P0610 is output A
      DTC is not output B

    B
    A