ECD SYSTEM, Diagnostic DTC:P0500

DTC Code DTC Name
P0500 Vehicle Speed Sensor "A"

DESCRIPTION

Vehicles which are equipped with a manual transaxle detect the vehicle speed using the speed sensor. The speed sensor transmits an 8-pulse signal for every revolution of the rotor shaft, which is rotated by the transaxle output shaft via the driven gear. The 8-pulse signal is converted into a more precise rectangular waveform by the waveform shaping circuit inside the combination meter. The signal is then transmitted to the ECM. The ECM determines the vehicle speed based on the frequency of the pulse signal.

A01CIJDE28
P0500
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Drive the vehicle at 10 km/h (6.3 mph) or more

Conditions (a), (b) and (c) are met for 8 seconds or more (2 trip detection logic):

(a) Engine coolant temperature is higher than 70°C (158°F).

(b) Engine speed: 1500 to 2500 rpm

(c) No speed signal is input to the ECM.


  • Open or short in vehicle speed sensor circuit

  • Vehicle speed sensor

  • Combination meter assembly

  • ECM

Conditions (a) and (b) are met for 5 seconds or more (2 trip detection logic):

(a) The fuel-cut operation is being performed (during deceleration).

(b) No speed signal is input to the ECM.

WIRING DIAGRAM

A01CH94E01

INSPECTION PROCEDURE

Note

After replacing the ECM, the new ECM needs registration Click here and initialization Click here.

Tech Tips

Read freeze frame data using the intelligent tester. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.

PROCEDURE


  1. READ VALUE USING INTELLIGENT TESTER (VEHICLE SPEED)


    1. Drive the vehicle and check whether the operation of the speedometer in the combination meter assembly is normal.

      Tech Tips


      • The vehicle speed sensor is operating normally if the speedometer reading is normal.

      • If the speedometer does not operate, check it by following the procedure described in the speedometer malfunction.


    NG
    OK
  2. CHECK ECM (SPD VOLTAGE)


    1. A01CI90E02
      Text in Illustration
      *a

      Component with harness connected

      (ECM)

      *b Wheel Turned

      Drive the vehicle.

    2. Measure the voltage between the terminals of the ECM connectors as the wheel is turned slowly.

      Standard Voltage
      Tester Connection Specified Condition
      E39-7 (SP1) - E38-1 (E1) Generated intermittently

      Tech Tips


      • The output voltage should fluctuate up and down similarly to the diagram when the wheel is turned slowly.

      • The maximum voltage value of the output waveform varies depending on the devices (tachograph, etc.) connected to the circuit.


    NG
    OK
  3. CHECK HARNESS AND CONNECTOR (COMBINATION METER ASSEMBLY - ECM)


    1. Disconnect the combination meter assembly connector.

    2. Disconnect the ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance (Check for Open)
      Tester Connection Condition Specified Condition
      E39-7 (SP1) - C18-23 (SP03) Always Below 1 Ω
      Standard Resistance (Check for Short)
      Tester Connection Condition Specified Condition
      E39-7 (SP1) or C18-23 (SP03) - Body ground Always 10 kΩ or higher
    4. Reconnect the combination meter assembly connector.

    5. Reconnect the ECM connector.


    NG
    OK