ECD SYSTEM, Diagnostic DTC:P0106

DTC Code DTC Name
P0106 Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem

DESCRIPTION

By a built-in sensor unit, the manifold absolute pressure sensor detects the intake manifold pressure as a voltage. The ECM then determines the basic injection duration and basic ignition advance angle based on this voltage.

Since the manifold absolute pressure sensor does not use the atmospheric pressure as a criterion, but senses the absolute pressure inside the intake manifold (the pressure in proportion to the preset absolute vacuum 0), it is not influenced by fluctuations in the atmospheric pressure due to high altitude and other factors. This permits it to control the air fuel ratio at the proper level under all conditions.

P0106
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
After warming up the engine, idle it for 10 seconds. Voltage output of the manifold absolute pressure sensor is out of the standard range (2 trip detection logic).
  • Manifold absolute pressure sensor

  • Intake system (leaks or blockages)

  • Vacuum hose connection for manifold absolute pressure sensor

  • ECM

INSPECTION PROCEDURE

Tech Tips

If DTCs P0107 and P0108 are output simultaneously, the manifold absolute pressure sensor circuit may be open or shorted. Perform troubleshooting for those DTCs first.

PROCEDURE


  1. CHECK OTHER DTC OUTPUT


    1. Replace the normal DLC3 cable (12 V specification) for the intelligent tester with the 24 V DLC3 cable.

      Note

      Be sure to use the 24 V DLC3 cable when connecting the intelligent tester to the DLC3. Using the normal DLC3 cable (12 V specification) will cause damage to the tester.

    2. Connect the intelligent tester to the DLC3.

    3. Turn the ignition switch to ON.

    4. Turn the tester on.

    5. Enter the following menus: Powertrain / Engine and ECT / DTC.

    6. Read the DTCs.

      Result
      Result Proceed to
      DTC P106 is output A
      DTC P106 and other DTCs are output B

    B
    A
  2. INSPECT INTAKE SYSTEM


    1. Inspect the intake system Click here.


    NG
    OK
  3. CHECK CONNECTION OF VACUUM HOSE


    1. Check the connection of the manifold absolute pressure sensor vacuum hose.


    NG
    OK
  4. INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR


    1. Inspect the manifold absolute pressure sensor Click here.


    NG
    OK