REPAIR INSTRUCTION VEHICLE LIFT AND SUPPORT LOCATIONS


  1. NOTICE ABOUT VEHICLE CONDITION WHEN RAISING VEHICLE


    1. The vehicle must be unloaded before jacking up or raising the vehicle. Never jack up or raise a heavily loaded vehicle.

    2. Set the jack and safety stands exactly under the specified locations on the vehicle.

    3. Never try to jack up or raise a vehicle that exceeds the weight specifications of the equipment being used.

    4. When raising the vehicle, first raise the vehicle only a little, and then shake the vehicle slightly to make sure it is stable before raising it to the specified position.

    5. Before removing the jack, tap the safety stands with a hammer or equivalent to make sure that the vehicle is properly supported.

    6. When using a lift, always lower the vehicle when work is not being performed.

    7. When removing any heavy components like the engine or transmission, the vehicle's center of gravity will shift. To stabilize the vehicle, place a balance weight in a location that will prevent the vehicle from rolling or shifting, or place a transmission jack under the appropriate jack position at the opposite end of the vehicle.

  2. NOTICE FOR USING 4 POST LIFT


    1. Follow the instruction manual for a safety operation.

    2. Do not damage tires or wheels with a free wheel beam.

    3. Using a wheel stopper, fix the vehicle.

  3. NOTICE FOR USING JACK AND SAFETY STAND


    1. Work in the flat place using a wheel stopper all the time.

    2. Support the specified location a jack and safety stand accurately.

    3. Do not work or leave the vehicle with a support only by a jack. Be sure to support the vehicle together with a safety stand.

    4. Be careful and accurate in jacking up and down the vehicle.

      A01CHMNE01

      Note

      If the front end of the frame cannot be supported using safety stands due to the front stabilizer bar, raise the vehicle after removing the front stabilizer bar and support the vehicle with safety stands.