POWER TAKE-OFF ASSEMBLY (for Power Take Off Electric Type) REMOVAL


  1. RAISE REAR DECK


    1. A01CHK6E01
      Text in Illustration
      *1 Safety Support
      *2 Safety Bar

      When working with the rear deck raised, use precautions to prevent the rear deck from falling.

    2. Use wheel chocks to secure the vehicle.

    3. Set the safety bar.

    4. Support the safety bar with safety supports.

      Note

      Make sure that the bezel is securely supported by the safety bar and that the safety bar does not move.

  2. DRAIN MANUAL TRANSMISSION OIL


    1. Remove the filler plug and O-ring.

    2. Remove the drain plug and O-ring, and then drain the manual transmission oil.

    3. Install a new O-ring and the drain plug.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }
  3. REMOVE PTO DRIVE SHAFT ASSEMBLY


    1. A01CGOTE01
      Text in Illustration
      *a Matchmark

      Place matchmarks on the power take-off assembly and PTO drive shaft assembly.

    2. Remove the 4 bolts, 4 nuts, 4 washers and PTO drive shaft assembly.

  4. REMOVE POWER TAKE-OFF ASSEMBLY


    1. Disconnect the 2 connectors.

    2. A01CH06

      Remove the 6 nuts, 6 washers and power take-off assembly.