DC / DC CONVERTER REMOVAL

Note

If the voltage converter sub-assembly has been dropped, replace it with a new one.


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. A01CIGM

      Detach the 13 clips and remove the center instrument cluster finish panel sub-assembly.

    2. Disconnect each connector.

  4. REMOVE INSTRUMENT PANEL BOX ASSEMBLY


    1. A01CH6R

      Detach the 6 clips and remove the instrument panel box.

  5. REMOVE INSTRUMENT PANEL BOX HOLDER


    1. A01CH9CE01

      Remove the 2 screws <E> and 2 instrument panel box holders.

  6. REMOVE LOWER INSTRUMENT COVER


    1. A01CHVG

      Detach the 4 clips and remove the lower instrument cover.

  7. REMOVE LOWER INSTRUMENT PANEL


    1. A01CJ1AE01

      Remove the clip.

    2. Remove the 3 bolts <D>.

    3. Detach the 8 clips and remove the lower instrument panel.

  8. REMOVE NO. 1 INSTRUMENT PANEL BOX


    1. A01CIB2E01

      Remove the bolt <G>.

    2. Detach the 4 clips, claw and guide and remove the No. 1 instrument panel box.

    3. A01CHXT

      Detach the 2 clamps.

  9. REMOVE VOLTAGE CONVERTER WITH ECU BRACKET

    A01CHL3

    1. Disconnect the connector.

    2. Remove the 3 bolts and voltage converter with ECU bracket.

  10. REMOVE ECU BRACKET


    1. A01CJBE

      Remove the 3 bolts and ECU bracket.

  11. REMOVE VOLTAGE CONVERTER BRACKET


    1. A01CJHW

      Remove the 2 screws and voltage converter bracket from the voltage converter sub-assembly.

  12. REMOVE NO. 2 VOLTAGE CONVERTER BRACKET


    1. A01CIDV

      Remove the 2 screws and No. 2 voltage converter bracket from the voltage converter sub-assembly.