VOLTAGE CONVERTER SYSTEM ON-VEHICLE INSPECTION


  1. INSPECT DC/DC CONVERTER


    1. A01CHBVE19

      Disconnect the X17 connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      D8-1 (+24V) - Body ground Always 20 to 28 V
      D8-3 (EMRI) - Body ground Ignition switch in ON position 20 to 28 V

      Tech Tips

      If the result is not as specified, repair or replace the harness or connector.

    3. A01CHBVE20

      Measure the resistance according to the value(s) in the table below.

      Standard resistance
      Tester Connection Condition Specified Condition
      D8-4 (SIG) - Body ground Always Below 1 Ω

      Tech Tips

      If the result is not as specified, repair or replace the harness or connector.

    4. Remove the DC/DC converter.

    5. A01CHS4E12

      Reconnect the D8 connector.

    6. Measure the voltage according to the value(s) in the table below.

      Standard voltage
      Tester Connection Condition Specified Condition
      D8-2 (OUT1) - Body ground Ignition switch in ON position 11 to 14 V
      D8-6 (IND) - Body ground Ignition switch in ON position 20 to 28 V
      D8-7 (OUTM) - Body ground Always 11 to 14 V
      D8-8 (OUT2) - Body ground Ignition switch in ON position 11 to 14 V

      Tech Tips

      If the result is not as specified, replace the DC/DC converter Click here.