ENGINE IMMOBILISER SYSTEM, Diagnostic DTC:B279A

DTC Code DTC Name
B279A Theft Deterrent System Communication Line High Fixation

DESCRIPTION

When the communication line (EFIO-IMI) between the transponder key ECU assembly and ECM is stuck on HI output, the ECM stores this DTC.

DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B279A The communication line (EFIO-IMI) between the ECM and transponder key ECU assembly is stuck on HI output (1 trip detection logic*).
  • Harness or connector

  • Transponder key ECU assembly

  • ECM

Turn the ignition switch to ON and wait 6 seconds.

WIRING DIAGRAM

A01CGPPE02

INSPECTION PROCEDURE

Note


  • When replacing the transponder key ECU assembly or ECM, refer to the Service Bulletin.

  • Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. CLEAR DTC


    1. Clear the DTCs Click here.


    NEXT
  2. CHECK FOR DTC


    1. Check for DTCs Click here.

      Result
      Result Proceed to
      DTC B279A is output A
      DTC B279A and other DTCs are output B

      Tech Tips

      If any DTCs other than DTC B279A are output, troubleshoot those DTCs first.


    B
    A
  3. CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - ECM)


    1. Disconnect the T18 transponder key ECU assembly connector.

    2. Disconnect the E40 ECM connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      T18-13 (EFIO) - E40-9 (IMI) Always Below 1 Ω
      E40-9 (IMI) - Body ground Always 10 kΩ or higher
    4. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      E40-9 (IMI) - Body ground Always Below 1 V

    NG
    OK
  4. CHECK ECM (TERMINAL IMI)


    1. Using an oscilloscope, check the waveform.

      A01CH8PE02
      Text in Illustration
      *a

      Component with harness connected

      (ECM)

      *b Waveform
      Measurement Condition
      Item Content
      Tester Connection E40-9 (IMI) - E38-1 (E1)
      Tool Setting 5 V/DIV., 50 ms./DIV.
      Condition Ignition switch ON

      Tech Tips


      • The waveform shown in the illustration is an example for reference only. Noise, chattering, etc. are not shown.

      • If you forget to note the waveform, etc. and need to recheck it, disconnect and reconnect the ECM connector before rechecking it.

      OK
      Waveform is output normally (refer to illustration).

    NG
    OK
  5. REPLACE TRANSPONDER KEY ECU ASSEMBLY


    1. Temporarily replace the transponder key ECU assembly with a new one (refer to the Service Bulletin).


    NEXT
  6. REGISTER ECU - ECM COMMUNICATION ID


    1. Register the ECU - ECM communication ID (refer to the Service Bulletin).


    NEXT
  7. CLEAR DTC


    1. Clear the DTCs Click here.


    NEXT
  8. CHECK FOR DTC


    1. Check for DTCs Click here.

      OK
      DTC B279A is not output.

    NG
    OK