ENGINE IMMOBILISER SYSTEM, Diagnostic DTC:B2797

DTC Code DTC Name
B2797 Communication Malfunction No. 1

DESCRIPTION

The antenna coil receives key code signals from the transponder chip in the key grip. The antenna coil is built into the transponder key amplifier, which amplifies the key code signals and outputs the signals to the transponder key ECU assembly.

This DTC is stored when there is an open or short in the antenna coil.

DTC Code DTC Detection Condition Trouble Area DTC Output Confirmation Operation
B2797 There is an open or short in the antenna coil (1 trip detection logic*).
  • Key

  • Transponder key amplifier

  • Transponder key ECU assembly

Insert the key into the ignition key cylinder.

WIRING DIAGRAM

A01CIOVE31

INSPECTION PROCEDURE

Note


  • When replacing the transponder key ECU assembly or key, refer to the Service Bulletin.

  • After performing repairs, perform the DTC output confirmation operation, and then confirm that no DTCs are output again.

PROCEDURE


  1. CHECK WHETHER ENGINE STARTS WITH OTHER KEYS


    1. Check if the engine starts with an already registered vehicle key.

      OK
      Engine starts.

    NG
    OK
  2. CHECK TRANSPONDER KEY ECU ASSEMBLY


    1. Insert a registered key into the ignition key cylinder.

    2. A01CJF6E01
      Text in Illustration
      *1 Noise
      *a

      Component with harness connected

      (Transponder Key ECU Assembly)

      Using an oscilloscope, check that there is no noise in the signal from terminal 15 (CODE) of the transponder key ECU.

      Measurement Condition
      Item Content
      Tester Connection 15 (CODE) - Body ground
      Tool Setting 5 V/DIV., 20 ms./DIV.
      Condition Registered key inserted into ignition key cylinder
      OK
      No noise is present (See illustration).

    NG
    OK
  3. CHECK TRANSPONDER KEY ECU ASSEMBLY


    1. Insert a registered key into the ignition key cylinder.

    2. A01CJF6E01
      Text in Illustration
      *1 Noise
      *a

      Component with harness connected

      (Transponder Key ECU Assembly)

      Apply an electrical load, and then, using an oscilloscope, determine whether there is noise in the signal at terminal 15 (CODE) of the transponder key ECU.

    3. Using an oscilloscope, check the waveform.

      Measurement Condition
      Item Content
      Tester Connection 15 (CODE) - Body ground
      Tool Setting 5 V/DIV., 20 ms./DIV.
      Condition Registered key inserted into ignition key cylinder
      OK
      No noise is present (See illustration).

    NG
    OK
  4. REPLACE TRANSPONDER KEY AMPLIFIER


    1. Temporarily replace the transponder key amplifier with a new or normally functioning one Click here.

    2. Clear the DTCs Click here.


    NEXT
  5. CHECK FOR DTC


    1. Check for DTCs Click here.

      OK
      DTC B2797 is not output.

    NG
    OK