DESCRIPTION
The antenna coil receives key code signals from the transponder chip in the key grip. The antenna coil is built into the transponder key amplifier, which amplifies the key code signals and outputs the signals to the transponder key ECU assembly.
This DTC is stored when there is an open or short in the antenna coil.
| DTC Code | DTC Detection Condition | Trouble Area | DTC Output Confirmation Operation |
|---|---|---|---|
| B2784 | The antenna coil built into the transponder key amplifier is open or shorted (determined by communication with the transponder key ECU assembly) (1 trip detection logic*). Either condition is met:
|
|
Insert the key into the ignition key cylinder. |
*: Only output while a malfunction is present.
WIRING DIAGRAM
INSPECTION PROCEDURE
Note
When replacing the transponder key ECU assembly or key, refer to the Service Bulletin.
After performing repairs, perform the DTC output confirmation operation, and then confirm that no DTCs are output again.
PROCEDURE
CHECK WHETHER ENGINE STARTS WITH OTHER KEYS
Check if the engine starts with an already registered vehicle key.
| OK |
|---|
| Engine starts. |
| NG |
|
CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) Click here |
| OK |
|
REREGISTER KEY CODE OR REPLACE KEY THAT CANNOT START ENGINE
CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER)
Disconnect the T18 transponder key ECU connector.
Disconnect the T17 transponder key amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | |||||||||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
| NG |
|
REPAIR OR REPLACE HARNESS OR CONNECTOR |
| OK |
|
CHECK TRANSPONDER KEY ECU ASSEMBLY (VC5, AGND)
| *a | Front view of wire harness connector (to Transponder Key Amplifier) |
Disconnect the T17 transponder key amplifier connector.
Measure the voltage according to the value(s) in the table below.
| Standard Voltage | ||||||
|---|---|---|---|---|---|---|
|
Measure the resistance according to the value(s) in the table below.
| Standard Resistance | ||||||
|---|---|---|---|---|---|---|
|
| NG |
|
REPLACE TRANSPONDER KEY ECU ASSEMBLY |
| OK |
|
REPLACE TRANSPONDER KEY AMPLIFIER
Temporarily replace the transponder key amplifier with a new or normally functioning one Click here.
Clear the DTCs Click here.
| NEXT |
|
CHECK FOR DTC
Check for DTCs Click here.
| OK |
|---|
| DTC B2784 is not output. |
| NG |
|
REPLACE TRANSPONDER KEY ECU ASSEMBLY |
| OK |
|
END (TRANSPONDER KEY AMPLIFIER WAS DEFECTIVE)