ANTI-LOCK BRAKE SYSTEM, Diagnostic DTC:C1417

DTC Code DTC Name
C1417 High Power Supply Voltage Malfunction

DESCRIPTION

If a malfunction is detected in the power supply circuit, the skid control ECU (brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS operation.

This DTC is stored when the IG terminal voltage deviates from the DTC detection condition due to a malfunction in the power supply or charging circuit such as the battery or generator circuit, etc.

The DTC is cancelled when the IG terminal voltage returns to normal.

DTC NO. DTC Detection Condition Trouble Area
C1417 IG terminal voltage is 33 V or more for 0.8 seconds or more continuously.
  • ECU-IG NO. 1 fuse

  • Battery

  • Charging system

  • Harness or connector

  • Brake actuator assembly

WIRING DIAGRAM

Refer to DTC C1241 Click here.

INSPECTION PROCEDURE

Note

Inspect the fuses for circuits related to this system before performing the following inspection procedure.

PROCEDURE


  1. INSPECT BATTERY


    1. Inspect the battery voltage.

      Standard voltage
      20 to 28 V

    B
    A
  2. READ VALUE USING INTELLIGENT TESTER (IG1 VOLTAGE VALUE)


    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Replace the normal DLC3 cable (12 V specification) for the intelligent tester with the 24 V DLC3 cable.

      Note

      Be sure to use the 24 V DLC3 cable when connecting the intelligent tester to the DLC3. Using the normal DLC3 cable (12 V specification) will cause damage to the tester.

    4. Connect the intelligent tester to the DLC3.

    5. Turn the ignition switch to ON.

    6. Turn the intelligent tester on.

    7. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

    8. According to the display on the intelligent tester, perform the Data List.

      ABS/VSC/TRC
      Tester Display Measurement Item/Range Normal Condition Diagnostic Note
      IG1 Voltage Value IG voltage value / Min.: 0.00 V, Max.: 40.00 V - Changes in proportion to auxiliary battery voltage
      OK
      20 to 28 V

    NG
    OK
  3. RECONFIRM DTC


    1. Clear the DTC Click here.

    2. Check if the same DTC is recorded Click here.

      Result
      Result Proceed to
      DTC is not output A
      DTC is output B

    B
    A