CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during electrical key removal/installation are shown below.
| Replaced Part or Performed Procedure | Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed | Link |
|---|---|---|---|
| Rear bumper assembly (w/ Intelligent clearance sonar system) |
|
Intelligent clearance sonar system |
PROCEDURE
REMOVE REAR BUMPER ASSEMBLY
REMOVE REAR BUMPER ENERGY ABSORBER (for Type A)
REMOVE REAR BUMPER ENERGY ABSORBER (for Type B)
REMOVE ELECTRICAL KEY ANTENNA
|
Remove in this Direction |
Disconnect the connector.
Remove the nut.
Disengage the guide to remove the electrical key antenna as shown in the illustration.
Note
Be careful when removing the electrical key antenna. If the electrical key antenna is dropped, replace it with a new one.