OIL PRESSURE SWITCHING VALVE INSTALLATION

PROCEDURE


  1. INSTALL OIL PRESSURE SWITCHING VALVE ASSEMBLY


    1. A01RAD0C05
      *1 O-Ring

      Apply a small amount of engine oil to the O-ring of the oil pressure switching valve assembly.

    2. Install the oil pressure switching valve assembly to the water inlet housing with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • When reusing the oil pressure switching valve assembly, inspect the O-ring.

      • Make sure that the O-ring is not cracked or jammed when installing the oil pressure switching valve assembly.

  2. INSTALL NO. 1 WATER BY-PASS PIPE

    Click here

  3. INSTALL NO. 4 EXHAUST MANIFOLD HEAT INSULATOR

    Click here

  4. INSTALL NO. 3 EXHAUST MANIFOLD HEAT INSULATOR

    Click here

  5. INSTALL ENGINE OIL LEVEL DIPSTICK GUIDE

    Click here

  6. INSTALL TURBOCHARGER SUB-ASSEMBLY

    Click here

  7. INSPECT FOR OIL LEAK

    Click here