AFS (ADAPTIVE FRONT-LIGHTING SYSTEM), Diagnostic DTC:B2424 and B2425
| DTC Code | DTC Name |
|---|---|
| B2424 | Headlight Leveling Motor LH Communication Malfunction |
| B2425 | Headlight Leveling Motor RH Communication Malfunction |
DESCRIPTION
The AFS ECU (headlight swivel ECU assembly) receives a signal from each headlight swivel motor using LIN communication.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
B2424 |
Headlight Leveling Motor LH Communication Malfunction |
|
|
B2425 |
Headlight Leveling Motor RH Communication Malfunction |
|
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
If the AFS ECU (headlight swivel ECU assembly) has been replaced, it is necessary to synchronize the vehicle information and initialize the AFS ECU (headlight swivel ECU assembly).
PROCEDURE
CHECK FOR DTC
Clear the DTCs.
Body Electrical > AFS > Clear DTCs
Check for DTCs.
Body Electrical > AFS > Trouble Codes
OK
DTC B2424 or B2425 is not output.
Result
Proceed to
OK
NG
CHECK HARNESS AND CONNECTOR (AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY) - HEADLIGHT UNIT)
Disconnect the A93 AFS ECU (headlight swivel ECU assembly) connector.
Disconnect the A90 headlight unit LH connector and A123 headlight unit RH connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
LH Side (B2424)
Tester Connection
Condition
Specified Condition
A93-30 (LHT) - A90-4 (LHM+)
Always
Below 1 Ω
A93-30 (LHT) - Body ground
Always
10 kΩ or higher
Standard Resistance
RH Side (B2425)
Tester Connection
Condition
Specified Condition
A93-11 (RHT) - A123-4 (RHM+)
Always
Below 1 Ω
A93-11 (RHT) - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
CHECK HEADLIGHT UNIT (HEADLIGHT SWIVEL MOTOR)
Replace the headlight unit with a new or known good one.
Check for DTCs.
Body Electrical > AFS > Trouble Codes
OK
DTC B2424 or B2425 is not output.
Result
Proceed to
OK
NG
OK END (HEADLIGHT SWIVEL MOTOR WAS DEFECTIVE)