CONTINUOUSLY VARIABLE TRANSAXLE SYSTEM(for 8NR-FTS), Diagnostic DTC:U110387

DTC Code DTC Name
U110387 Lost Communication with Stop and Start Control Module Missing Message

DESCRIPTION

The ECM and engine stop and start ECU send and receive signals via CAN communication.

If a communication error occurs between the ECM and engine stop and start ECU, the ECM stores this DTC.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

Note

U110387

Lost Communication with Stop and Start Control Module Missing Message

1. Diagnosis Condition 2. Malfunction Status 3. Malfunction Time 4. Other

  1. The ignition switch is ON.

  2. There is no communication between the ECM and stop and start ECU.

  3. 1.16 seconds or more

  4. 1-trip detection logic

  • ECM

  • Engine stop and start ECU

  • CAN communication system

Does not come on

DTC stored

SAE Code:

U1103

CAUTION / NOTICE / HINT

Tip:

After performing repair, clear the DTCs and perform the following procedure to check that DTCs are not output.

  1. Check that the battery voltage is 9.5 V or more.

  2. Turn the ignition switch to ON.

  3. Check for DTCs again.

    Click here

PROCEDURE

  1. CLEAR DTC AND PERFORM ROAD TEST

    1. Clear the DTCs.

      Powertrain > Transmission > Clear DTCs

      Tip:

      Write down the currently output DTCs before clearing them.

    2. Start the engine and drive the vehicle at a low speed.

    Result

    Proceed to

    NEXT

    NEXT
  2. CHECK DTC OUTPUT (DTC U110387)

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Transmission / Trouble Codes.

      Powertrain > Transmission > Trouble Codes

    5. Read the DTCs using the GTS.

    Result

    Result

    Proceed to

    DTC U110387 is not output

    A

    DTC U110387 is output

    B

    A

    CHECK FOR INTERMITTENT PROBLEMS

    B

    GO TO CAN COMMUNICATION SYSTEM