HEATER SWITCH INSPECTION

PROCEDURE

  1. INSPECT HEATER SWITCH ASSEMBLY

    1. E145141C02

      *a

      Component without harness connected

      (Heater Switch Assembly)

      Measure the resistance.

      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance

        Tester Connection

        Condition

        Specified Condition

        4 (IG) - 1 (IN)

        Heater switch assembly: On

        Below 1 Ω

        4 (IG) - 1 (IN)

        Heater switch assembly: Off

        10 kΩ or higher

    2. Check the operation indicator.

      1. Turn the heater switch assembly on.

      2. Connect a positive (+) lead from the battery to terminal 4 (IG) and a negative (-) lead to terminal 5 (E), and check that the operation indicator comes on.

        OK

        Indicator comes on.

        If the result is not as specified, replace the heater switch assembly.