CRUISE CONTROL SYSTEM(for 1ND-TV without Driving support ECU), Diagnostic DTC:P0500
| DTC Code | DTC Name |
|---|---|
| P0500 | Vehicle Speed Sensor Malfunction |
DESCRIPTION
The cruise control system uses the same vehicle speed signal that is sent to the ECM for the ECD system. If DTC P0500 is detected, perform diagnosis using the inspection procedure for DTC P0500 in the ECD system. The speed signal is converted for use by the cruise control inside the ECM. Both the ECD system and the cruise control system can set DTC P0500, however, the detection conditions of the two systems are different.
*1: Refer to ECD System
Click hereClick hereClick here
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
P0500 |
Vehicle Speed Sensor Malfunction |
The vehicle speed signal from the vehicle speed sensor stops for 0.14 sec. or more while the cruise control system is controlling vehicle speed. |
|
WIRING DIAGRAM
Refer to ECD System (for 1ND-TV).
CAUTION / NOTICE / HINT
This DTC may be output by the ECD system at the same time. In that case, perform troubleshooting for the ECD system first.
PROCEDURE
CHECK FOR DTCS (DTC P0500)
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Clear the DTCs.
Powertrain > Cruise Control > Clear DTCs
Perform the following to make sure that the DTC detection conditions are met.
Tip:If the detection conditions are not met, the malfunction cannot be detected.
Drive the vehicle for more than 10 seconds when the engine coolant temperature is more than 20°C (68°F).
Check for DTCs.
Powertrain > Cruise Control > Trouble Codes
Result
Result
Proceed to
DTC is not output
A
DTC P0500 is output
B