FUEL SYSTEM ON-VEHICLE INSPECTION
PROCEDURE
FUEL PRESSURE
Read Data List
Note:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tip:Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Warm up the engine.
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Data List.
Read the Data List.
Tester Display
Measurement Item/Range
Normal Condition
Fuel Press
Fuel pressure/
Min.: 0 kPa, Max.: 655350 kPa
Idling: 27000 to 45000 kPa
Target Common Rail Pressure
Target common rail pressure/
Min.: 0 kPa, Max.: 655350 kPa
32000 to 200000 kPa when engine running
INSPECT FOR FUEL LEAK
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test.
Powertrain > Engine and ECT > Active Test
Tester Display
Test the Fuel Leak
Perform the Active Test.
Tester Display
Measurement Item
Control Range
Diagnostic Note
Test the Fuel Leak
Pressurize the common rail interior and check for fuel leaks
Stop/Start
Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2000 rpm when ON is selected.
Above conditions preserved while test is ON.
Tip:If this Active Test is performed when the engine is cold, combustion may become unstable. However, this is not a malfunction. It is only necessary to confirm that the pressure rises to the target pressure and that there are no fuel leaks.