REAR DOOR BELT MOULDING(for Hatchback, Wagon) REMOVAL
CAUTION / NOTICE / HINT
Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
PRECAUTION (w/ Power Window)
Note:After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)
Note:When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereClick hereClick hereClick hereClick hereClick here
REMOVE REAR ARMREST ASSEMBLY (w/o Power Window)
REMOVE REAR ARMREST ASSEMBLY (w/ Power Window)
REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)
REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)
REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
REMOVE REAR DOOR SERVICE HOLE COVER
DISCONNECT REAR DOOR WEATHERSTRIP
-
Disengage the clip and disconnect the rear door weatherstrip.
-
DISCONNECT REAR DOOR GLASS RUN
REMOVE REAR DOOR REAR WINDOW GUIDE WITH REAR DOOR REAR GUIDE SEAL
REMOVE REAR DOOR GLASS SUB-ASSEMBLY
REMOVE REAR DOOR GLASS RUN
REMOVE REAR DOOR BELT MOULDING ASSEMBLY
Resin Type:
-
*a
Protective Tape

Protective Tape
Put protective tape around the rear door belt moulding assembly.
Using a screwdriver with its tip wrapped with protective tape, disengage the 6 claws and remove the rear door belt moulding assembly as shown in the illustration.
Tip:Tape the screwdriver tip before use.
-
Plating Type:
-
*a
Protective Tape

Protective Tape
Put protective tape around the rear door belt moulding assembly.
Using a screwdriver with its tip wrapped with protective tape, disengage the 5 claws and remove the rear door belt moulding assembly as shown in the illustration.
Tip:Tape the screwdriver tip before use.
-