POWER STEERING SYSTEM, Diagnostic DTC:C1515
| DTC Code | DTC Name |
|---|---|
| C1515 | Torque Sensor Zero Point Adjustment Undone |
DESCRIPTION
This DTC does not indicate a malfunction. The power steering ECU assembly stores this DTC when it determines that torque sensor zero point calibration has not been performed.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Warning Indicate |
Return-to-normal Condition |
Note |
|---|---|---|---|---|---|---|
C1515 |
Torque Sensor Zero Point Adjustment Undone |
This DTC is stored when torque sensor zero point calibration has not been performed. |
- |
EPS Warning Light: Comes on |
Zero point calibration occurs |
There is no malfunction if this DTC is not output again after performing zero point calibration. |
CAUTION / NOTICE / HINT
If the electric power steering column sub-assembly has been replaced with a new one, perform torque sensor zero point calibration.
If the power steering ECU assembly has been replaced with a new one, perform assist map writing and torque sensor zero point calibration.
PROCEDURE
CHECK FOR DTC
Calibrate the torque sensor zero point (step 1).
Chassis > EMPS > Utility
Tester Display
Torque Sensor Adjustment
Check for DTCs (step 2).
Chassis > EMPS > Trouble Codes
Tip:If DTCs are output, perform steps 1 and 2 two more times.
Result
Result
Proceed to
DTCs are still output after performing steering zero point calibration 3 times.
A
Normal system code is output.
B
B END
REPLACE POWER STEERING ECU ASSEMBLY
Replace the power steering ECU assembly.
Result
Proceed to
NEXT
CHECK FOR DTC
Calibrate the torque sensor zero point (step 1).
Chassis > EMPS > Utility
Tester Display
Torque Sensor Adjustment
Check for DTCs (step 2).
Chassis > EMPS > Trouble Codes
Tip:If DTCs are output, perform steps 1 and 2 two more times.
Result
Result
Proceed to
DTCs are still output after performing steering zero point calibration 3 times.
A
Normal system code is output.
B
B END