PRE-CRASH SAFETY SYSTEM Pre-crash Safety System Cancel Switch Circuit

DTC Code DTC Name
Pre-crash Safety System Cancel Switch Circuit

DESCRIPTION

Each time the pre-crash system cancel switch assembly is pressed, the multi-information display sensitivity setting display changes and the sensitivity of the pre-crash safety system changes between 3 levels. Also, when the switch is pressed and held, the pre-crash safety system cancels.

WIRING DIAGRAM

E297408E28

CAUTION / NOTICE / HINT

Note:
  • When replacing the pre-crash safety city sensor, replace it with a new one and be sure to initialize the settings. If a pre-crash safety city sensor which was installed to another vehicle is used, the information stored in the pre-crash safety city sensor will not match the information from the vehicle and, as a result, a DTC may be stored.

  • If the pre-crash safety city sensor has been replaced, or the windshield glass has been replaced or removed/installed, be sure to perform Recognition Camera/Target Position Memory and Recognition Camera Axis Adjust.

    Click hereClick here

PROCEDURE

  1. CHECK HARNESS AND CONNECTOR (PRE-CRASH SYSTEM CANCEL SWITCH ASSEMBLY - PRE-CRASH SAFETY CITY SENSOR AND BODY GROUND)

    1. Disconnect the E131 pre-crash system cancel switch assembly connector.

    2. Disconnect the O9 pre-crash safety city sensor connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      E131-4 (ECU) - O9-9 (PCSW)

      Always

      Below 1 Ω

      E131-1 (GND) - Body ground

      Always

      Below 1 Ω

      E131-4 (ECU) - Body ground

      Always

      10 kΩ or higher

    Result

    Proceed to

    OK

    NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK
  2. INSPECT PRE-CRASH SAFETY CITY SENSOR

    1. Remove the pre-crash system cancel switch assembly.

      Click hereClick here

    2. Inspect the pre-crash system cancel switch assembly.

      Click here

    Result

    Proceed to

    OK

    NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    NG

    REPLACE PRE-CRASH SAFETY CITY SENSOR