SIMPLE INTELLIGENT PARKING ASSIST SYSTEM, Diagnostic DTC:U0073,U0100,U0101,U0126,U0129,U0131,U0142,U0151,U0164 and U1103

DTC Code DTC Name
U0073 Control Module Communication Bus "A" Off
U0100 Lost Communication with ECM / PCM "A"
U0101 Lost Communication with TCM
U0126 Lost Communication with Steering Angle Sensor Module
U0129 Lost Communication with Brake System Control Module
U0131 Lost Communication with Power Steering Control Module
U0142 Lost Communication with Body Control Module "B"
U0151 Lost Communication with Restraints Control Module
U0164 Lost Communication with HVAC Control Module
U1103 Lost Communication with Stop and Start Control Module

DESCRIPTION

These DTCs are stored if there is a malfunction in the CAN communication system connected to the clearance warning ECU assembly.

Tip:

If CAN communication system DTCs are stored, they may also be stored in other systems.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

U0073

Control Module Communication Bus "A" Off

Control module communication bus off

CAN communication system

U0100

Lost Communication with ECM / PCM "A"

Lost communication with ECM

CAN communication system

U0101

Lost Communication with TCM

Lost communication with transmission control ECU assembly

CAN communication system

U0126

Lost Communication with Steering Angle Sensor Module

Lost communication with spiral cable with sensor sub-assembly

CAN communication system

U0129

Lost Communication with Brake System Control Module

Lost communication with brake actuator assembly (skid control ECU)

CAN communication system

U0131

Lost Communication with Power Steering Control Module

Lost communication with power steering ECU assembly

CAN communication system

U0142

Lost Communication with Body Control Module "B"

Lost communication with main body ECU (multiplex network body ECU)

CAN communication system

U0151

Lost Communication with Restraints Control Module

Lost communication with airbag sensor assembly

CAN communication system

U0164

Lost Communication with HVAC Control Module

Lost communication with air conditioning amplifier assembly

CAN communication system

U1103

Lost Communication with Stop and Start Control Module

Lost communication with engine stop and start ECU

CAN communication system

PROCEDURE

  1. CHECK DTC OUTPUT

    1. Clear the DTCs.

      Click here

      Body Electrical > Clearance Sonar / Simple-IPA. > Clear DTCs

    2. Recheck for DTCs and check if the same DTC is output again.

      Body Electrical > Clearance Sonar / Simple-IPA. > Trouble Codes

      OK

      No DTCs are output.

      Tip:
      • If CAN communication system DTCs are stored, they may also be stored in other systems.

      • If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.

      • If these DTCs are output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.

    Result

    Proceed to

    OK

    NG

    OK

    USE SIMULATION METHOD TO CHECK

    NG

    GO TO CAN COMMUNICATION SYSTEM

    w/ Central Gateway ECU:Click here

    w/o Central Gateway ECU:Click here