POWER STEERING SYSTEM FAIL-SAFE CHART

If a problem occurs in the power steering system, the power steering assist will be stopped, locked at a particular point, or decreased simultaneously to protect the system.

Table 1. Power Steering System

DTC No.

Detection Condition

Fail-safe

C1511

Torque sensor malfunction

Assist force restricted or power assist stopped

C1512

C1513

C1514

C1515

This DTC is stored when torque sensor zero point calibration has not been performed

C1516

Torque sensor zero point calibration is incomplete due to the steering wheel being touched during calibration

C1517

Torque sensor malfunction

C1521

Motor overcurrent

C1522

Motor current sensor malfunction

C1523

Excessively large current deviation

C1524

Short (or open) in motor circuit or abnormal voltage or current in motor circuit

C1528

Motor rotation angle sensor malfunction

Power assist stopped

C1531

ECU internal malfunction (CPU malfunction)

Assist force restricted or power assist stopped

C1532

ECU internal malfunction (Peripheral circuit malfunction)

C1533

ECU internal malfunction (Substrate temperature sensor malfunction)

C1534

ECU internal malfunction (EEPROM error)

C1541

This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more

Assist force restricted

C1551

Open or short in IG power source circuit with ignition switch ON

Power assist stopped

C1552

PIG power source circuit malfunction

C1554

Power source relay circuit malfunction

C1555

Motor relay circuit malfunction

C1581

Assist map not written in power steering ECU assembly

Controlled using default map

C1582

Assist map mismatch written in power steering ECU assembly

Controlled using current default map

U0100

Lost communication with ECM

Assist force restricted

U0129

Lost communication with skid control ECU

Tip:
  • The amount of power assist may be decreased to prevent the motor and ECUs from overheating if the steering wheel is continuously turned when the vehicle is either stopped or driven at a low speed, or if the steering wheel is kept at either full lock position for a long time. In such cases, the amount of power assist returns to normal if the steering wheel is not turned for approximately 10 minutes with the engine running.

  • If the battery is not sufficiently charged or the voltage decreases temporarily, the amount of power assist will be reduced and the EPS warning light will come on. In such cases, the amount of power assist returns to normal when the battery voltage recovers.