PRE-CRASH SAFETY SYSTEM CANCEL SWITCH INSPECTION

PROCEDURE

  1. INSPECT PRE-CRASH SYSTEM CANCEL SWITCH ASSEMBLY

    1. B392607C03

      *a

      Component without harness connected

      (Pre-crash System Cancel Switch Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      4 (ECU) - 1 (E)

      Pushed

      Below 25 Ω

      Not pushed

      100 kΩ or higher

      If the result is not as specified, replace the pre-crash system cancel switch assembly.

    2. Illumination Inspection

      1. Apply auxiliary battery voltage to the pre-crash system cancel switch assembly and check that the switch illuminates.

        OK

        Condition

        Specified Condition

        Auxiliary battery positive (+) → Terminal 3 (ILL+)

        Auxiliary battery negative (-) → Terminal 2 (ILL-)

        Illuminates

        If the result is not as specified, replace the pre-crash system cancel switch assembly.