TIRE PRESSURE WARNING SYSTEM, Diagnostic DTC:C2162/62

DTC Code DTC Name
C2162/62 Communication Line Switch

DESCRIPTION

There is a switch circuit inside the tire pressure warning ECU and receiver. The tire pressure warning ECU and receiver switches to the tire pressure warning system function when an IG ON signal is received and switches to the wireless door lock control system (w/o Entry and Start System) function when an IG OFF signal is received. If the tire pressure warning ECU and receiver does not switch to the tire pressure warning system function when an IG ON signal is received, DTC C2162/62 is stored.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

C2162/62

Communication Line Switch

The tire pressure warning ECU and receiver does not switch to the tire pressure warning system function when an IG ON signal is received.

Tire pressure warning ECU and receiver

-

CAUTION / NOTICE / HINT

Note:
  • When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the GTS and write them down before removal.

  • It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.

PROCEDURE

  1. CHECK DTC OUTPUT (C2162/62)

    1. Clear the DTCs.

      Click here

      Chassis > Tire Pressure Monitor > Clear DTCs

    2. Turn the ignition switch off.

    3. Turn the ignition switch to ON.

    4. Check for DTCs.

      Click here

      Chassis > Tire Pressure Monitor > Trouble Codes

      OK

      DTC C2162/62 is not output.

      Result

      Proceed to

      OK

      NG

    OK

    USE SIMULATION METHOD TO CHECK

    NG

    REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

    for Sedan:Click here

    for Wagon:Click here

    for Hatchback:Click here