GLOW PLUG REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click hereClick here

  2. REMOVE NO. 1 ENGINE COVER

  3. WARM UP ENGINE

    Note:

    The glow plug assembly may be damaged if it is removed before the engine is warmed up.

  4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  5. REMOVE NO. 2 EGR PIPE SUB-ASSEMBLY

  6. REMOVE ENGINE COVER BRACKET

    1. A264950

      Remove the bolt, nut and engine cover bracket.

  7. REMOVE NO. 1 GLOW PLUG CONNECTOR

    1. A264951

      Disconnect the glow connector.

    2. Remove the bolt and disconnect the engine wire so that the glow plugs can be removed in a later step.

    3. A264953

      Remove the 4 grommets.

    4. A264952

      Disconnect the clamp from the bracket.

    5. A264954

      Remove the 4 nuts and No. 1 glow plug connector.

  8. REMOVE GLOW PLUG ASSEMBLY

    1. A197247

      Using a 10 mm deep socket wrench, remove the 4 glow plug assemblies.

      Note:

      Do not remove the glow plug assemblies before the engine is warmed up.