SIMPLE INTELLIGENT PARKING ASSIST SYSTEM, Diagnostic DTC:C164A

DTC Code DTC Name
C164A EPS Communication Malfunction

DESCRIPTION

This DTC is stored when the clearance warning ECU assembly receives communication malfunction signal from the power steering ECU assembly via CAN communication.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

C164A

EPS Communication Malfunction

EPS communication malfunction

  • Power steering system

  • Power steering ECU assembly

  • Clearance warning ECU assembly

CAUTION / NOTICE / HINT

Note:

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization may be needed. Refer to Initialization.

Click here

PROCEDURE

  1. CHECK DTC OUTPUT

    1. Clear the DTCs.

      Click here

      Body Electrical > Clearance Sonar / Simple-IPA. > Clear DTCs

    2. Recheck for DTCs and check if the same DTC is output again.

      Body Electrical > Clearance Sonar / Simple-IPA. > Trouble Codes

      OK

      No DTCs are output.

      Tip:
      • If the DTC is not output again when rechecking for DTCs, it may have been stored due to a temporary communication problem between the clearance warning ECU assembly and power steering ECU assembly.

      • If DTC C164A is output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.

    Result

    Proceed to

    OK

    NG

    OK

    USE SIMULATION METHOD TO CHECK

    NG
  2. REPLACE CLEARANCE WARNING ECU ASSEMBLY

    1. Replace the clearance warning ECU assembly.

      for LHD:Click here

      for RHD:Click here

    Result

    Proceed to

    NEXT

    NEXT
  3. CHECK DTC OUTPUT

    1. Clear the DTCs.

      Click here

      Body Electrical > Clearance Sonar / Simple-IPA. > Clear DTCs

    2. Recheck for DTCs and check if the same DTC is output again.

      Body Electrical > Clearance Sonar / Simple-IPA. > Trouble Codes

      OK

      No DTCs are output.

    Result

    Proceed to

    OK

    NG

    OK

    END (CLEARANCE WARNING ECU ASSEMBLY WAS DEFECTIVE)

    NG
  4. CHECK DTC OUTPUT (POWER STEERING SYSTEM)

    1. Check for DTCs.

      Click here

      Chassis > EMPS > Trouble Codes

      OK

      No DTCs are output.

    Result

    Proceed to

    OK

    NG

    OK

    REPLACE POWER STEERING ECU ASSEMBLY

    NG

    GO TO POWER STEERING SYSTEM