ROOF SUNSHADE SYSTEM TERMINALS OF ECU

  1. CHECK ROOF SUNSHADE ECU (SLIDING ROOF DRIVE GEAR ASSEMBLY)

    B270994N07
    1. Disconnect the a1 roof sunshade ECU (sliding roof drive gear assembly) connector.

    2. Measure the resistance and voltage according to the value(s) in the table below.

      Tip:

      Measure the values on the wire harness side with the connector disconnected.

      Tester Connection

      Wiring Color

      Terminal Description

      Condition

      Specified Condition

      a1-8 (B) - a1-12 (E)

      R-W - B-W

      Battery power supply

      Always

      11 to 14 V

      a1-1 (IG) - a1-12 (E)

      R - B-W

      IG power supply

      Ignition switch off

      Below 1 V

      a1-1 (IG) - a1-12 (E)

      R - B-W

      IG power supply

      Ignition switch ON

      11 to 14 V

      a1-12 (E) - Body ground

      B-W - Body ground

      Ground

      Always

      Below 1 Ω

      If the result is not as specified, there may be a malfunction in the wire harness.

    3. Reconnect the a1 roof sunshade ECU (sliding roof drive gear assembly) connector.

    4. Measure the voltage according to the value(s) in the table below.

      Tester Connection

      Wiring Color

      Terminal Description

      Condition

      Specified Condition

      a1-7 (OPEN) - a1-12 (E)

      G - B-W

      Roof sunshade motor open

      Ignition switch ON, open switch on

      Below 1 V

      a1-7 (OPEN) - a1-12 (E)

      G - B-W

      Roof sunshade motor open

      Ignition switch ON, open switch off

      11 to 14 V

      a1-5 (CLOSE) - a1-12 (E)

      L - B-W

      Roof sunshade motor close

      Ignition switch ON, close switch on

      Below 1 V

      a1-5 (CLOSE) - a1-12 (E)

      L - B-W

      Roof sunshade motor close

      Ignition switch ON, close switch off

      11 to 14 V

      If the result is not as specified, the roof sunshade ECU (sliding roof drive gear assembly) may be malfunctioning.