BATTERY CURRENT SENSOR REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. REMOVE BATTERY STATE SENSOR ASSEMBLY

    1. A351889

      Remove the nut and disconnect the engine wire from the battery state sensor assembly.

      Note:

      When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

      Click hereClick hereClick hereClick here

    2. A351890

      Loosen the nut and remove the battery state sensor assembly from the battery.

    3. A351891

      Disengage the clamp and disconnect the battery state sensor assembly connector.

    4. A351892

      Disengage the 2 claws to remove the battery state sensor assembly from the battery state sensor holder.